Magnetic flap level meter often what problems, in the magnetic flap level meter failure, how to deal with, know how to judge the magnetic flap level meter and overhaul, the following is a simple analysis of the magnetic flap level meter will often encounter some of the failure.

In the actual industrial production, often encountered in the tank level measurement, magnetic flap level meter is one of the common measurement tools. The magnetic flap level gauge is a simple direct indication level meter working under high pressure, because of its own structure makes it unique, reliable and economical is not compared with other meters, as a basic level indication instrument in simple level measurement occasions and a high degree of automation in large engineering projects are indispensable. Magnetic flap level meter in use will encounter many problems, these problems are mainly due to people's unskilled operation and installation errors caused by the following we will introduce you to these aspects of knowledge. The liquid pathway constituted by the main body of the magnetic flap level meter is connected to the measured vessel with a flange or cone thread through the receiver to form a connecting device, and the liquid level observed through the glass plate is the same as the liquid level in the vessel, that is, the level height.

Magnetic flap level meter at the beginning of the installation, the instrument must be maintained in a vertical state, which is the basic requirements of the installation of the instrument. The liquid medium to be measured should not contain solid impurities or magnetic substances, otherwise it is easy to affect the accuracy of the measurement caused by the snagging of the float. At the same time, it is required that a ball valve should be installed between the magnetic flap level meter and the vessel lead pipe to facilitate the maintenance and disassembly of the level meter for cleaning.

Magnetic flap level meter in the selection of installation location needs to pay attention to avoid or away from the material media import and export, so as not to lead to too drastic changes in the local area of the material fluid, the accuracy of the level measurement.

When commissioning the meter, first open the upper lead pipe valve, then slowly open the lower valve, let the liquid medium slowly and smoothly into the leading tube (during operation, care should be taken not to let the liquid medium sharply impact the float, causing strong fluctuations in the float, which will affect the accuracy of the display), carefully observe whether the magnetic red and white ball flip is normal, after confirming normal, then you can close the lower lead pipe valve, open the drain valve, let the leading After confirming that it is normal, then you can close the valve of the lower lead pipe, open the drain valve, and let the liquid level in the lead pipe drop, repeat the above steps three times, and make sure that it is normal, then the magnetic flip flop level meter can be operated.

After a long time of use, the magnetic flip plate is often due to internal accumulation of dirt and other attached crops, so that the measurement of the instrument error, it is necessary to clean the level meter, the level meter for disassembly and cleaning need to pay attention to the above process, first open the bottom flange, and then take out the magnetic float for cleaning, especially to draw attention to: after the completion of cleaning and installation of magnetic float must be heavy end with magnetic end up, must not Otherwise, the level meter will not work properly. Before use, you should use the correction magnet to set the small ball below the zero level into red, and the other balls into white.

The above is for the magnetic flap level meter will often appear what failure? What is the solution? The answer to this question, have other ideas or questions can always contact us!