BETTER TOUCH BETTER BUSINESS
Contact Sales at KAIDI.
"All according to the instructions on the installation, how to measure or so big error"; "this radar level meter will not have problems, right, after the installation, or no echo signal". Have you also encountered such problems when installing radar level meter. In fact, sometimes it is not the installation steps are not correct, but the installation ignored some details, resulting in inaccurate measurement or can not be measured. The following points of installation supplement, I hope that you can install the magnetrol radar level transmitters no longer fret.
Supplementary one: When installing, pay attention to the strength of the top plate of the tank. Radar level meter if there are fluctuations in displacement, it is easy to cause inaccurate measurement. To avoid this situation, pay attention to the strength of the top plate when installing.
Supplementary two: when installing, pay attention to the two avoidance. The reason why the radar level meter is not allowed to measure, in most cases, is that the interference signal affects the measurement. Therefore, when installing the radar level meter, pay attention to avoiding the inlet and avoiding internal disturbances.
Supplementary III: When installed, the total length of the connecting pipe as well as the flange of the radar level meter receiver port should be less than 250 mm. The reason for this is that the radar wave signal can enter the inside of the storage tank smoothly for rotary paddle level measurement.
Supplementary four: the radar level meter is installed inside the wave-guide tube, the wave-guide should be theoretically vertical downward and maintain a vertical relationship with the liquid level, the real working condition allows a slight deviation, but the deviation should be less than or equal to 0.5 degrees.
Supplementary five: the installation of radar level meter inside the guide wave tube, the guide wave tube should be made according to the actual situation on site, not a complete set of purchase. Site conditions are very different, in order to ensure that the radar level meter can accurately measure the level. Wave guide tube should be specially customized, and as far as possible to the whole, welding as far as possible not to have burrs and welding seams.
Radar level meter of the measurement error, many cases are not to pay attention to these details, resulting in the echo signal interference, measurement errors. To avoid these situations, the best solution is to master some installation-related knowledge, and pay more attention to the installation.
We are here to help you! If you close the chatbox, you will automatically receive a response from us via email. Please be sure to leave your contact details so that we can better assist