KAIDI wholesale radar type level transmitter company for industrial

Company Advantages
1. The necessary tests for KAIDI have been conducted. These tests include flexibility testing, dimension stability testing, slip resistance testing, and fatigue resistance testing. This product has the feature of explosion-proof
2. The product can keep its appearance excellent after washing. People can be assured that it will not shrink or out of shape after washing. With a simple structure, it is perfectly good for demanding industrial applications
3. The product is resistant to ozone. It is not easy to occur drying, cracking, flaking, hardening and scaling when exposed to ozone. This product consumes little energy thanks to its energy-saving technology
4. The product is flame retardant. All roofs and side walls comply with the requirements of flame retardant B1 building materials class. This product stands out for its high sensitivity
5. The product is highly resistant to shock, vibrations, and external impacts, which makes it easily exposed to rough conditions indoor or outdoor. This product is notable for its strong overload capacity

I. Principle

Radar level transmitter antenna microwave pulse is narrow, the downward transmission antenna. Microwave exposure to the medium surface is reflected back again by the antenna system receives, sends the signal to the electronic circuit automatically converted into level signals (because the microwave propagation speed, electromagnetic wave to reach the target and the reflected back to the receiver this time is almost instantaneous).

A    Range set

B    Low adjustment

C    High

Datum measurement:  Screw thread bottom or the sealing surface of the flange.

Note: Make sure the radar level meter the highest level cannot enter the measuring blind area

II. The characteristics of 26G radar level meter:

Ø  Beam angle is small, the energy is concentrated, can enhance the ability of echo and to avoid interference.

Ø  Small antenna size, easy to install; Non-contact radar, no wear, no pollution.

Ø  Low weight of about 1kg, convienient for installation.

Ø  Maximum measuring range up to 30m, covering large reservior's level measurement.

Ø  Various output circuit interface and acquisition system.

Ø  Almost no corrosion, bubble effect; almost not affected by water vapor in the atmosphere, the temperature and pressure changes.

III. Product  Introduction

• 908s
  

IV. Structure Size

• Shell Size

Ø  Aluminum Shell 

Ø  Plastic Shell

• Product Size: 

• Size of Hydraulic Fission Displayer (if there was):

• Woodwork Size:

V. Technical Parameters

The outer shell 

The seal between the shell and the shell cover                 Silicone rubber

Casing window                                                                   Polycarbonate

The ground terminal                                                           Stainless steel

 

The power supply voltage

Allowable ripple

- <100Hz                                  Uss<lV   

- (100~100K) Hz                      Uss<l0mV

Flameproof:

DC 24V / 4~20mA / 0.75W power dissipation      2-wire system

(6 ~24)V DC /  Modbus-RS485 / 90mW power dissipation    4-wire system

 

The cable parameters

Cable entrance / plug           1  M20xl.5 cable entrance

Terminal                               Conductor cross section 1.0mm² 

 

Output parameters

The output signal                              (4 ~ 20) mA /RS485

Communication protocol                   HART

Resolution                                        1.6μA

Fault signal                                       Constant current output;

20. 5mA

22mA

3.9mA

The integral time                               (0 ~ 36) s, adjustable

 

Blind area                                         the ends of the antenna

 

The maximum distance measurement                  30 meters

 

Microwave frequency                                              26GHz

 

Communication interface                                       HART communication protocol

 

The measurement interval       about 1 second (depending on the parameter settings)

 

Adjust the time                          about 1 second (depending on the parameter settings)

Display resolution                    1 mm

Working storage and transportation temperature                            (-40～80) ℃

Process temperature (the temperature of the antenna part)                (-40～80)℃ 

Pressure                                     0.1MPa

Seismic                                       Mechanical vibration l0m/s², (10 ~ 150) Hz

Company Features
1. Our manufacturing shop is equipped with efficient and modern production machines. They enable our workers to finish their tasks as smoothly as possible and process customers' orders quickly and flexibly.
2. Taking as designing tenet, Guangdong Kaidi Energy Technology Co., Ltd. innovates continually and lead the trend in radar type level transmitter field. Get info!