Vibrating Level Switch

PRODUCT INTRODUCTION

Vibrating Rod Level Switches provide reliable level detection of powders and bulk solids. This com- pact, integral switch is suitable for high or low level detection in hoppers or silos. It may also be used for plugged chute detection.

Features

● Single rod design eliminates clogging

● High temperature version up to +320 °F (+160 °C)

● Self-clean cycle and polished probe minimize solids buildup

● Class I, Div. 2 and Class II, Div. 1 approval

● Adjustable sensitivity allows easy calibration for various bulk densities

● Extended rigid probes up to 100 inches (2540 mm)

● Extended flexible lengths to 65 feet (20 meters)

Self-testing:

● After power-on, red light on, the probe begin vibrate, put hand on the probe, the relay will work and red light off, then let hand off the probe, after 1-2 seconds, the red light will on again.

● Sensitivity selection: set according to material, typically it’s set on HIGH sensitivity.

● 1. In high temperature environment, try to set on LOW sensitivity.

Detection:

● When probe touch the material, the probe stop vibrate, the relay will work and red light off (its opposite if “NO”)

● When material leave off the probe for 1-2 seconds, the red light will on again, the relay will work (its opposite if “NO”)