Caddy KD YH300 Vibrating Fork Level Switch

Product Description

Product Use

Product Parameters

Operating instructions

 end connected), and then put the fork body into the material in two lights at the same time (NO end and COM end connected, NC end and COM end disconnected); this time it is adjusted. (Note that the factory has been set up, customers do not need to set up again, unless the failure)

Special Note

1. This intelligent tuning fork self-test function, on the one hand, in order to overcome the fork body installed in the barrel wall after the vibration absorption phenomenon, on the other hand, in order to prevent noise interference, to avoid malfunctioning 2. The factory set value of the product is to the density of water (1G/CM3), as a state of switching the benchmark, when the density of the material to be measured is less than 1G/CM3, you need to re-self-test 3. The sensitivity of the factory set to the highest, the sensitivity is set to the highest. Applicable to the place where the material to be measured is relatively stable. If the fluctuation of the surface of the material to be measured is large, the sensitivity needs to be adjusted downward to prevent the occurrence of false alarms.

4. When installing the device, please try to avoid locations with obvious vibration to prevent the device from malfunctioning. If this is unavoidable, please re-test the device at the installation location or restore the factory settings.

Selection table