Magnetic flap level gauge assembly process

What should be paid attention to in the installation of magnetic flap level gauge? The assembly process of the magnetic flap level gauge 1. There should be no magnetic conductive material around, and iron wire fixing is prohibited, otherwise it will affect the normal operation of the magnetic flap level gauge; 2. When using the heat tracing pipeline by yourself, you must use non-magnetic conductive materials. , such as copper pipes, etc. The heat tracing temperature is determined according to the medium; 3. The magnetic flap level gauge must be installed vertically, and a ball valve should be installed between the magnetic flap level gauge and the container lead pipe to facilitate maintenance and cleaning; 4. The medium should not contain solid impurities or magnetic substances to avoid blocking the float; 5. Before use, the small ball below the zero position should be set to red with a calibration magnet, and the other balls to be white; 6. Open the bottom flange and install the magnetic float ( The magnetic end of the heavy end is upward, and cannot be installed upside down.); 7. During debugging, the upper lead pipe valve should be opened first, and then the lower valve should be opened slowly to allow the medium to enter the main pipe smoothly. Column fluctuations will affect the display accuracy), observe whether the magnetic red and white balls are turned normally, then close the valve of the lower lead pipe, open the drain valve, and let the liquid level in the main pipe drop. Corrosive and other special liquids are excluded); 8. According to the medium conditions, the main pipe should be cleaned irregularly to remove impurities; 9. For more than a certain length (ordinary type>3 meters, anti-corrosion type>2 meters) of the liquid level gauge, it is necessary to increase the middle reinforced flange or the lug as a fixed support to increase the strength and overcome its own weight; 10. The installation position of the magnetic flap liquid level gauge should avoid or keep away from the inlet and outlet of the material medium To avoid rapid changes in the local area of ​​the material and fluid, which will affect the accuracy of liquid level measurement; 11. When equipped with a remote transmission instrument, the following must be done: a) The remote transmission instrument should be close to the liquid level gauge leader. b) The sensing surface of the remote supporting instrument should face and close to the main pipe; c) The zero position of the remote supporting instrument should be on the same horizontal line as the zero position indication of the liquid level gauge d) The connection between the remote transmission supporting instrument and the display instrument or the industrial computer should preferably be laid through a protective tube or with a shielded two-core cable; e) After the wiring hole of the junction box is laid, it is required to be well sealed to avoid rainwater. The remote transmission supporting instrument cannot work normally due to the intrusion of moisture, etc., the junction box should be covered in time after the maintenance or debugging is completed.

Guangdong Kaidi Energy Technology Co., Ltd. has created its reputation on a commitment to manufacturing high-quality products and services while satisfy the needs of customers.

Guangdong Kaidi Energy Technology Co., Ltd. has had manufacturing experience for over customized level indicator years. She currently runs a website where they sell . You can visit her site at Kaidi level indicator.

To have a that needs much precaution in handling, it is best to rely only on reliable providers. Guangdong Kaidi Energy Technology Co., Ltd. can provide quality customized level indicator level gauge that meet all your requirements for a while meet your individual needs.