top misalignment switch manufacturers for transportation

Product Description

High-quality stainless steel casting, high strength, never rust, IP67 protection rating, and good sealing. Pull Cord Switch is an emergency switch to stop the belt conveyor instantly when an accident happens. Since the Pull Cord Switch is so designed that it should be installed at the side of belt conveyor and the pull cord should be mounted along conveyor, the switch can be actuated at any position. Weatherproof type: IP67. The internal contact is the high performance micro switch from Japan, with high contact capacity. It can directly control high capacity contactor, with 2 normally open and 2 normally closed output. Additionally, we also produce pull cord switch with the internal contact close to the sensor .

WIRING DIAGRAM

KAIDI misalignment switch manufacturers for transportation-1

Drawings

a. Auto-reset

KAIDI misalignment switch manufacturers for transportation-2

b. Manual reset

ENVIRONMENTAL CONDITIONS

The Pull Cord Switch should be used in the following environmental conditions; especially made products should be used at the allowable conditions noted in the approved drawing or the final drawing.

l Temperature －10°C～＋50°C

Do not use the Pull Cord Switch in the place where there is danger of freezing.

l Humidity less than 80%

l Dust

If much dust adheres to the touch roller and it solidifies the Pull Cord Switch will not move normally.

To prevent dust from adhering to the touch roller, it should be cleaned at regular intervals.

l Explosive and Corrosive Environment

The standard Pull Cord Switch should never be use under these conditions.

INSTALLATION

Fitting bolts

The fitting bolts should be prepared before installation, and should be fitted into the mounting holes according to the length.

Mounting Base

The mounting base fitted to the belt conveyor should be prepared before installation. When you are deciding the dimensions of the mounting base, refer to Product drawing.

Installation

Prepare the necessary installation frame according to the size of the belt conveyor frame

MAINTENANCE

Periodic Inspection

(1)Cleaning

Always clean when an excessive amount of dust accumulates on the touch roller.

(2)Action check

Check to see if the Pull Cord Switch is working normally by Pull the cord.

Lubrication

The Pull Cord Switch has no need to lubricate.

Tightening of Cover

When taking off the cover of Pull Cord Switch for the sake of writing, adjusting and checking, secure the screws of the cover after working, or the Pull Cord Switch may cause trouble due to water and dust entering from between the cover and casing.

k******u

Digital molding technique and meta-mechanical analysis are used in the development of Kaidi Sensors misalignment switch by the R&D team. The team strives to create a product with high precision which suits most people's foot arch.

o******a

The quality of Kaidi Sensors misalignment switch is constantly monitored by using advanced measuring equipment such as a wide range of height, bore, and other gaging equipment, and hardness tester equipment.

q******w

The casting process of Kaidi Sensors misalignment switch is professionally completed, including final magnetic tumbling, casting preparation, creation of ring castings, clip and ship services, and laser review.

y******x

Kaidi Sensors misalignment switch is made from polymers that are made up of many many molecules strung together to form long chains that behave differently.

c******f

Except for workers' inspection, Kaidi Sensors misalignment switch will be inspected by machine QC which can thoroughly measure the dimension and check other properties.

i******z

This product has electromagnetic compatibility. It does not emit levels of EM energy that can cause electromagnetic interference in other devices in the vicinity.

Product Message

*Name

Phone

*E-mail

*Content