KAIDI conveyor pull rope switch suppliers for transportation

Company Advantages
1. Guangdong Kaidi Energy Technology Co., Ltd. can satisfy different design requirements.
2. The quality of this product is effectively controlled by implementing the quality control system.
3. A state-of-the-art infrastructure has been established in order to fabricate premium quality range of this product.
4. The product, used by an increasing number of people, has an extensive application prospect.

Product Description

High-quality stainless steel casting, high strength, never rust, IP67 protection rating, and good sealing. Pull Cord Switch is an emergency switch to stop the belt conveyor instantly when an accident happens. Since the Pull Cord Switch is so designed that it should be installed at the side of belt conveyor and the pull cord should be mounted along conveyor, the switch can be actuated at any position. Weatherproof type: IP67. The internal contact is the high performance micro switch from Japan, with high contact capacity. It can directly control high capacity contactor, with 2 normally open and 2 normally closed output. Additionally, we also produce pull cord switch with the internal contact close to the sensor .

 

WIRING DIAGRAM

 

Drawings

 

a. Auto-reset

 

   b. Manual reset

 

ENVIRONMENTAL CONDITIONS

The Pull Cord Switch should be used in the following environmental conditions; especially made products should be used at the allowable conditions noted in the approved drawing or the final drawing.

l  Temperature －10°C～＋50°C

Do not use the Pull Cord Switch in the place where there is danger of freezing.

l  Humidity less than 80%

l  Dust

If much dust adheres to the touch roller and it solidifies the Pull Cord Switch will not move normally.

To prevent dust from adhering to the touch roller, it should be cleaned at regular intervals.

l  Explosive and Corrosive Environment

The standard Pull Cord Switch should never be use under these conditions.

INSTALLATION

Fitting bolts

The fitting bolts should be prepared before installation, and should be fitted into the mounting holes according to the length.

Mounting Base

The mounting base fitted to the belt conveyor should be prepared before installation. When you are deciding the dimensions of the mounting base, refer to Product drawing.

Installation

Prepare the necessary installation frame according to the size of the belt conveyor frame

MAINTENANCE

Periodic Inspection

(1)Cleaning

Always clean when an excessive amount of dust accumulates on the touch roller.

(2)Action check

Check to see if the Pull Cord Switch is working normally by Pull the cord.

Lubrication

The Pull Cord Switch has no need to lubricate.

Tightening of Cover

When taking off the cover of Pull Cord Switch for the sake of writing, adjusting and checking, secure the screws of the cover after working, or the Pull Cord Switch may cause trouble due to water and dust entering from between the cover and casing.

Company Features
1. For years, Guangdong Kaidi Energy Technology Co., Ltd. has been offering excellent products such as belt misalignment switch , backed by the deep expertise of industry professionals.
2. Guangdong Kaidi Energy Technology Co., Ltd. has a huge pool of skilled workers.
3. Sustainability is what we strive for our long-term success. We are exploring new ways to increase energy efficiency and reduce waste in our daily production processes. A keen sense of customer service is an essential value for our company. This value will inspire and guide our daily behavior, encouraging us to make every effort to prioritize and meet the needs of our clients. Ask! We attach high importance to the common development of local communities. We are active in promoting communities' development. We will continue to take part in poor relief programs to drive local economic growth.