Radar Level Meter Flange Installation Instructions

Compared with contact instruments, radar level meters have strong advantages. The transmission of microwave signals is not affected by the atmosphere, and can meet the requirements of harsh environments such as volatile gases, high temperature, high pressure, steam, vacuum and high dust in the process. It can be used in harsh environments such as high temperature, high pressure, vacuum, steam, high dust and volatile gas. Continuous measurement of different material levels is possible. It can be used in a network and can be widely used in metallurgy, building materials, energy, petrochemical, water conservancy, food and other industries. The installation flange position matters are as follows: For accurate positioning, there are marks on the flange or thread. During installation, this mark must conform to the following directions. The specific matters are as follows: 1. The indicator mark of the flange should point to the tank wall or tank center of. 2. If using still-pipe installation, the flange mark should point to the side of the opening. 3. If a bypass pipe is used for installation, the flange mark should point to the side of the connecting pipe. 4. During the use of the radar, the amplitude of the echo signal indicates whether the installation position is the best, if the amplitude of the echo signal is low. 5. The flange can be rotated, and the interference echo can be minimized by rotating one hole at a time. In addition, false echo storage can be used to achieve the best measurement effect.