[Experience sharing] What are the reasons why the split electromagnetic flowmeter is easily damaged?

The most advantageous feature of electromagnetic flowmeter is bidirectional measurement, which can measure the fluid flow of strong corrosive liquids and mud, pulp, pulp, etc. Another advantage is that the measurement method can be changed according to the demand, which can display liters, kilograms, tons, and cubic meters. The electromagnetic flowmeter can be divided into: integrated electromagnetic flowmeter and split electromagnetic flowmeter due to different functions. The split electromagnetic flowmeter will inevitably be damaged in one way or another during operation. If any component is damaged, it will directly affect the entire shutdown, so we usually need to learn to observe, what is the cause of the damage to the components? The following editor analyzes the reasons why the split electromagnetic flowmeter is most likely to be damaged. The faults that occur during the initial commissioning and normal operation for a period of time during the operation period are mainly caused by the following five points: 1. The main reasons for the signal interference source are the same as the previous section in terms of the interference during the debugging period, but the interference source does not appear during the debugging period. Participate during operation. For example, an electromagnetic flowmeter with no ideal grounding protection. During the commissioning period, because there is no factory disturbance source, the instrument operates normally. However, during the operation period, a new disturbance source (such as a pipeline near the measurement point or pipeline welding is performed far away) interferes with the instrument. In normal operation, there is a large bump in the output signal. 2. Inner wall adhesion layer Since the electromagnetic flowmeter has more time to measure the suspended solid phase or dirt than other flow meters, the probability of interference caused by the inner wall adhesion layer is relatively high. If the conductivity of the adhesion layer is similar to the conductivity of the liquid, the meter can still output signals normally, but the smooth area is changed, forming a hidden obstacle to the measurement deviation; if the high conductivity adhesion layer, the electromotive force between the electrodes will be short-circuited; , the electrode surface is insulated and the measurement circuit is disconnected. The latter two symptoms can make the instrument unable to work. 3. Lightning strike Lightning strikes feel instantaneous high voltage and surge current in the line, and entering the meter will destroy the meter. There are 3 introduction paths for lightning strike damage instruments: power line, flow signal line and excitation line between sensors and converters. However, damage to components from lightning disturbances can also cause disturbances. Most of the high voltages and inrush currents are introduced from the control room power lines, and the other two are less. It is also learned from the scene of the lightning accident that not only the public electromagnetic flowmeter is obstructed, but other instruments in the control room often have lightning accidents at the same time. Therefore, the use of the unit should understand the importance of setting the lightning protection method of the instrument power line in the control room. 4. Electrode wear Due to the excessive flow rate of the medium in the pipeline, suspended particles, small iron filings and small stones will also damage the electrodes in the split electromagnetic flowmeter under the action of thrust, and the damage of the electrodes is a direct consequence. It is the entire inlet water of the flowmeter. 5. The position of the split-type electromagnetic flowmeter has strict standards for installation. It can be installed indoors or outdoors. The most feared is the dark and humid place as shown in Figure 1, because the humidity inside is too large, which will affect the internal flow of the flowmeter. It still has a direct impact, and it will damage the components in the long run. Figure 1 The split electromagnetic flowmeter is used as a measuring instrument. When damage is found, it must be discovered and dealt with in time, so as to ensure the normal, safe and efficient operation of the flowmeter.

We are a performance driven culture that uses level gauge to ensure continuous improvement.

Through our culture, our drive and the expertise of each individual employee, Guangdong Kaidi Energy Technology Co., Ltd. is uniquely positioned to provide best-in-class services to a global customer base.

is something that has been around for a few decades now, enjoying it's heyday back in the customized level indicator.

Guangdong Kaidi Energy Technology Co., Ltd. employs a numbers of citizens, helping them and their families achieve a higher standard of living.